Vedenlämpötilasensori
Lähetetty: 27 Maalis 2018, 13:32
Onko kellään tietoa sensoreista tarvis saada jostain seuraava.
FAE-7-87-3208-12V.
Saman näköinen kuin tässä kuvassa.
http://www.burtonpower.com/temperature- ... xtt14.html
Ohm alue mitattuna ilman lämpöisenä noin 250-270 ohm.
Kädessä kun pitää vähän aikaa niin vastusarvo noin 160 ohm.
Mittaristona autossa on 2.8I Caprin mittaristo.
Burtonilta ostettu XTT45 anturi joka pitäisi olla juurikin 2.8I Caprista ei toimi.
Siinä vastusarvo on kylmänä luokkaa 600-700ohm.
Käden lämpöisenä noin 550ohm.
Tietoa mikähän on minulle oikea? Burtonilta vastaus oli niin pyöreä, että huvittaa oikein, varsinkin kun
on ostettu 10£ tuote ja se on niin sanottua roskaa...
Hello,
The part you have would be correct for what is in the box for a 2.8 injection.
There is inconsistence with certain original gauges, There is a few different types as seen below for the cologne - carb and injection only models. So may be dependant on the gauge you have inside to -
Unfortunately we do not hold any resistance ohms ratings for senders.
That code does not cross reference with anything kept here as are more than like a batch number of some type not so match a part number.
Regards
Sean Beal
FAE-7-87-3208-12V.
Saman näköinen kuin tässä kuvassa.
http://www.burtonpower.com/temperature- ... xtt14.html
Ohm alue mitattuna ilman lämpöisenä noin 250-270 ohm.
Kädessä kun pitää vähän aikaa niin vastusarvo noin 160 ohm.
Mittaristona autossa on 2.8I Caprin mittaristo.
Burtonilta ostettu XTT45 anturi joka pitäisi olla juurikin 2.8I Caprista ei toimi.
Siinä vastusarvo on kylmänä luokkaa 600-700ohm.
Käden lämpöisenä noin 550ohm.
Tietoa mikähän on minulle oikea? Burtonilta vastaus oli niin pyöreä, että huvittaa oikein, varsinkin kun
on ostettu 10£ tuote ja se on niin sanottua roskaa...
Hello,
The part you have would be correct for what is in the box for a 2.8 injection.
There is inconsistence with certain original gauges, There is a few different types as seen below for the cologne - carb and injection only models. So may be dependant on the gauge you have inside to -
Unfortunately we do not hold any resistance ohms ratings for senders.
That code does not cross reference with anything kept here as are more than like a batch number of some type not so match a part number.
Regards
Sean Beal